CNC Machine Build Logs Page 1 >> Page 2 >> Page 3 >> Page 4 >> Page 5 >> Page 6 >> Page 7 >> Page 8 >> Page 9 >> Page 10
At the time of this writing, this CNC build doesn’t look like it’s finished, but the progress thus far looks good. It looks like it will have a laser attached to it when it’s finished. Note: The original site is in French, so the link goes to the Google translated version.
____________________________________________________________________
Here is a build log of a rather nice looking CNC. Note: The site is originally in Turkish, but has been translated at the link.
____________________________________________________________________
Here is a CNC build from the contraptor website. It’s based off of a kit they provide. The picture below shows it fully assembled.
____________________________________________________________________
____________________________________________________________________
Here is a CNC built from aluminum located on woodworkforums.com. Notice how it has a rather nifty laser point attached.
____________________________________________________________________
As you can see in the picture, this CNC build is still in it’s beginning stages, but it looks like the author is currently still working on it. At the time of this writing, it was updated just yesterday, so check back from time to time for more.
____________________________________________________________________
Here is a rather sturdy looking CNC machine. Not a whole lot of info, but cool nonetheless.
____________________________________________________________________
Here is a pretty cool CNC build with fairly decent documentation too. Note: The original page is in Polish but has been translated by Google into English.
____________________________________________________________________
Here is one very solid looking desktop sized CNC build. Note: The original page is in Swedish but has been translated by Google into English.
____________________________________________________________________
Here is a CNC machine with a large 5′ x 10′ cutting area. Both a router and plasma torch can be attached to it. There isn’t a whole lot of info on it, but there are some nice pictures. Don’t forget to also check out the builder’s other CNC table here.
____________________________________________________________________
Here is a nifty desktop sized CNC build log. I like the DIY motor couplers. Note: The original page is in Dutch but has been translated by Google into English.
CNC Machine Build Logs Page 1 >> Page 2 >> Page 3 >> Page 4 >> Page 5 >> Page 6 >> Page 7 >> Page 8 >> Page 9 >> Page 10
